V50 L5-2.4L VIN 39 B5244S7 (2005)
-
Punch out the holes (1) in the panel from the outside according to the markings. Use a 9.5 mm (3/8") diameter hole punch. Ensure that there is a
counterhold on the reverse of the panel. Do not damage the panel
-
Enlarge the guide holes (2) to a diameter of 3.5 mm (9/64") if this was not carried out previously. Use the scriber
-
Remove the tape.
-
Take two clips and locking washers from the kit. Press the clips into place in the holes in the side panel
-
Lock the clips using the locking washers on the reverse of the panel. Counterhold securely when installing the locking washers.
Reinstall:
-
the side panel. Tighten the screws for the load securing eyelets. Tighten to 24 Nm (18 lbf. ft.). Reinstall the covers
-
the lower panel on the C-post
-
the rubber strip at the rear edge of the opening for the rear door
-
the panel at the top/front of the side panel
-
the side cushion
-
Fold the backrest and seat back into place
-
Reinstall the rubber strip in the boot lid opening
-
Reinstall the tailgate sill trim panel
-
Reinstall the cargo compartment carpet.
