V50 L5-2.4L VIN 39 B5244S7 (2005)
wheel hub.
Note!
Clean all contact surfaces before gluing.
After the gluing procedure is completed, it is necessary that the car is not driven for approx 4-6 hours in order to allow the glue to set. Also, check the
general gluing instructions supplied with the Loctite glue.
Note!
It is allowed to move the car a short distance if this is done quickly after assembling the parts together (e.g. to remove the car from the hoist).
Note!
If later removing the drive shafts from the hubs, it can be helpful to use a hot air gun to heat up the parts before removal.
VOLVO STANDARD TIMES GUIDE (VSTG) INFO:
Operation number 99173-2 - Screw, drive axle, front, 2 sides- repl/Loctite acc to TJ - 0.8 hrs
- Claims may be submitted under the new car warranty when there is a documented customer complaint using claim type: 01
- Labor times are valid at the time of release and are subject to change.
