V50 L5-2.4L VIN 39 B5244S7 (2005)
Tighten the center screw holding the variable valve timing unit. Tighten to specification.
Tighten the screws for the exhaust timing belt pulley. Ensure that the screws are not in a limit position. Tighten to specification. Install the plug for the
VVT unit. Tighten to specification.
Adjusting belt tension
Slacken off the screw for the timing belt tensioner. Then turn the eccentric back so that the indicator reaches the marked position in the center of the
window. Remember to hold the center screw secure at the same time. Hold the eccentric in place and tighten the center screw. Tighten to specification.
Check that the indicator is in the correct position.
Removing the adjustment tools
Remove:
-
camshaft adjustment tools 999 5452 from the rear edge of the camshafts
-
crankshaft stop 999 5451. Install the plug with a new sealing washer. Tighten to specification.
Checking the markings and belt tension
