V50 L5-2.4L VIN 39 B5244S7 (2005)
-
Position the two remaining hose clamps on the hoses for the heater. See the illustration.
-
Move the heater into position behind the oil cooler. Press the heater hoses into the terminals in the oil cooler and pipes for the oil cooler
-
Take the three self tapping screws and three spacers from the kit. Tighten the bracket and heater to the rear edge of the oil sump.
Note! The screws are self-tapping, so it may be difficult to screw them in. Ensure that the screws are centered straight in the holes. The
screw heads must be positioned flat against the bracket.
-
Tighten the two loose hose clamps. Adjust the position of the heater connector so that it does not catch on the power steering hose or charge air
hose
-
Fully tighten the heater to the bracket.
