V50 L5-2.4L VIN 39 B5244S7 (2005)
Install the belt in the following order:
-
the crankshaft
-
the idler pulley
-
the intake camshaft pulley
-
the exhaust camshaft pulley
-
the water pump
-
the tension pulley.
This adjustment is done on a cold engine. A suitable temperature is approx. 20 °C/68 °F. At higher temperatures, e.g., with the engine at operating
temperature or a higher ambient temperature, the indicator assumes a position farther to the right. The figure shows the position of the indicator when
setting the timing belt tensioner at different engine temperatures.
Hold the center screw secure and turn the belt tensioner eccentric clockwise until the tensioner indicator passes the marked position and reaches the limit
position. Tighten.
Tighten the center screw that holds the VVT-unit (variable valve timing unit). Tighten according to: : Tightening torque See: Specifications/Mechanical
Specifications/Tightening Torque Tightening torques.
Tighten the screws for the exhaust timing belt pulley and make sure that the screws are not in end-position. Tighten according to: Tightening torque See:
Specifications/Mechanical Specifications/Tightening Torque.
Install the plug for the VVT-unit. Tighten according to: Tightening torque See: Specifications/Mechanical Specifications/Tightening Torque.
Adjusting belt tension
