V50 L5-2.4L VIN 39 B5244S7 (2005)
-
Pull off the rubber strip at the rear of the opening for the right-hand rear door.
-
Carefully pry off the lower panel on the C-post on the right-hand side. Pry the top edge using a weatherstrip tool. Pull in the C-post panel so that
the two upper clips release. Then continue pulling down until the last two clips release.
-
Fold out the load securing eyelets on the right-hand side panel.
-
Insert a scriber with an angled tip into the holes in the top of the covers (1). Turn the scriber so that the tip engages the reverse of the covers. Pull
the covers off.
-
Remove the screws in the load securing eyelets.
-
Remove the screw (2) at the front/top edge of the side panel.
-
Pull off the side panel at the top so that the two clips at the rear/bottom of the side window and the clip at the bottom of the D-pillar release.
-
Lift out the side panel.
-
Remove the insulation panel on the right-hand side. The insulation panel is secured by two clips behind the rear wheel arch.
Installation of the 12V socket, applies to the S40(04-) and V50
Applies to cars where the marking for the 12V socket hole is on the reverse of the side panel. Image A applies to the S40 (04-)
