V50 L5-2.4L VIN 39 B5244S7 (2005)
Installation
Installing the wheel sensor
Note! For tightening torques, see Specifications. See: Specifications/Mechanical Specifications/Starting and Charging
Install:
-
the wheel sensor in the connector
-
the connector
-
the M5 screw. Tighten. See: Tightening torque See: Specifications/Mechanical Specifications/Starting and Charging.
Finishing
Installing the shock absorber for vehicles equipped with Nivomat
Install:
-
the shock absorber from the lateral link
-
the M5 screw. Tighten. See: Tightening torque See: Specifications/Mechanical Specifications/Starting and Charging.
Function test
Read off any diagnostic trouble codes (DTCs) stored in the control module.
Erase.
Interrupt the diagnostic function by turning off the ignition.
Test drive the vehicle. See: Test Drive Form (ABS), description See: Brakes and Traction Control/Antilock Brakes / Traction Control Systems/Testing
and Inspection/Initial Inspection and Diagnostic Overview/Test Drive Form (ABS).
Check that no diagnostic trouble codes (DTCs) are stored. Interrupt the diagnostic function by turning off the ignition.
