V50 L5-2.4L VIN 39 B5244S7 (2005)
Continue - DONE
Numeric Result 0 - Communication fault
-------------------------------------------------
Communication fault
Communication has been interrupted for one of the following reasons:
-
The ignition is switched off
-
VCT2000 disconnected from the data link connector (DLC)
-
VCT2000 disconnected from the VIDA cart
-
Communication problems in VIDA application or in car.
-
No voltage in the data link connector (DLC).
Check therefore:
-
That the control module power supply and ground terminal are fault-free.
-
That the fuse for the data link connector (DLC) is intact.
-
that the ignition is on
-
that the battery voltage (system voltage) is normal (approximately 12 V).
If necessary a battery charger can be connected during the test.
For information about charge currents and the battery, see: Battery, charging See: Starting and Charging/Battery/Service Precautions/Battery, Charging
-
that VCT2000 is correctly connected to the VIDA cart and the data link connector (DLC)
-
that VCT2000 and the wiring is fault-free.
Other information
-
For information about fuse and terminal numbers, see the relevant Wiring Diagram.
Try to establish communication again or exit reading off diagnostic trouble codes (DTCs). Depending on the communication fault, select one of the
following options.
1. Try again
2. Fault-trace more comprehensively for the communication problem that has occurred
3. Exit fault-tracing / Read off from the next system.
-------------------------------------------------
Checking communication faults
Checking communication errors
Selecting car model
Select car model to obtain relevant troubleshooting information.
Select one of the following model alternatives
1. S40 (04-) / V50.
2. V70 (00-), V70 XC (01-) / XC70, S60, S80 and XC90.
3. V70 (-00), V70 XC and S70 / C70.
4. S40 (-04)/ V40.
1 - car model S40 (04-) / V50
