V50 L5-2.4L VIN 39 B5244S7 (2005)
Use tool: 951 2630 Terminal removal tool See: Tools and Equipment/951 2630 Terminal Removal Tool and tool: 951 2631 Terminal removal tool
See: Tools and Equipment/951 2631 Terminal Removal Tool to remove the primary lock. See the illustrations.
At the same time pull the cable carefully backwards.
Assembly
Note! Wheel sensor cables are twisted pair (positive and negative signal) cables for each wheel. It is important that paired cables are twinned in
the same way when they are reinstalled in the connector. The cables must be twisted approximately 3 times per 100 mm.
Assembling primary lock
Check that the cable terminal is undamaged.
Press the cable terminal into the housing.
Check that the cable terminal is properly locked by pulling carefully on the cable.
Assembling secondary lock
Press the secondary lock into place.
