volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Starting System - No Crank/No Start Diag. Information|Page 1114 > < Starting System - No Crank/No Start Diag. Information|Page 1112
Page 1
background image

Headlamp Control Module: Specifications

Component specification, Gas Discharge Lamp Module (GDL)

Front axle sensor and rear axle sensor

General

The sensors sense the angle of the vehicle at different loads and send the information to the "master" of the two Gas Discharge Lamp Modules (GDLs).
The "master" Gas Discharge Lamp Module (GDL) then sends control signals to the motors that regulate the beam length.

Type

Resistance sensor.

Characteristics

The resistance between connections 1 and 4 changes linearly depending on the angle.

Other information

One of the position sensors is located next to the rear axle and is connected to the left rear control arm via a link system. The other position sensor is
located next to the right front axle and is connected to the right front control arm via a link system. The vehicle's angle is measured by the sensors being
affected via the relevant link system.

Connection

Starting System - No Crank/No Start Diag. Information|Page 1114 > < Starting System - No Crank/No Start Diag. Information|Page 1112