V50 L5-2.4L VIN 39 B5244S7 (2005)
A timer control function can be connected to the electrical parking heater which is controlled via the accessory electronic module (AEM). The system
consists of:
-
a relay for the electrical parking heater
-
cable harness between the relay and the accessory electronic module (AEM).
The relay is mounted on the engine block heater and controls the electrical parking heater and relay passenger compartment socket.
The relay acts as a switch and is supplied with power and controlled via the wiring from the accessory electronic module (AEM).
The relay is connected to the ground terminal in the engine compartment.
When post-installing the timer start system for the electrical parking heater the vehicle must be configured using new software which is carried out via
VIDA.
There are diagnostics for the relay/control signal.
Alarm signal outputs
An after market alarm unit can be connected to the accessory electronic module (AEM). The system consists of four output signals which can be used as
input signals in the external alarm system via a cable harness. The accessory electronic module (AEM) uses the existing Controller area network (CAN)
to receive/forward signals for the vehicle alarm, key and door status.
When installing an after market alarm system the vehicle must be configured using new software. Configuration is carried out via VIDA.
There are diagnostics for the alarm signal outputs.
Tele-mute function for non-integrated mobile phones
The telemute function mutes the sound system when the mobile telephone rings.
The design consists of a signal input and a signal output. The input signal is digital (0 V/12 V) and the output signal is a Controller area network (CAN)
communication.
When post-installing the hands free unit the vehicle must be configured using new software. Configuration is carried out via VIDA.
There are diagnostics for the tele-mute function.
Function
Starting the parking heater via the timer
