V50 L5-2.4L VIN 39 B5244S7 (2005)
-
Drill two holes in the body as illustrated. Use a -5.0 mm (13/64") diameter drill bit. These holes must be used when securing the bracket for the
control module.
-
Treat the edges of the holes using a rust-proofing agent.
-
Remove any swarf.
-
Secure the bracket in the rear hole (1) in the body. Use a screw from the kit.
-
Adjust the bracket so that it is straight.
-
Use a scriber to make a mark, through the hole in the body, where the final hole will be drilled on the bracket.
-
Remove the bracket from the body. Drill out the hole. Use a -3.5 mm (9/64") diameter drill bit.
-
Treat the edges of the holes using a rust-proofing agent.
-
Rust-proof the hole edges in the bracket.
-
Take the Accessory Electronic Module (AEM) from the kit and press it into the bracket.
Illustration A
