V50 L5-2.4L VIN 39 B5244S7 (2005)
Take the adapter wiring from the kit and connect it to the Accessory Electronic Module (AEM) as follows:
-
Plug the black (SB) four pin connector (1) into the control module.
-
Connect the white (W) two pin male connector (2) to the white (W) pre-routed two pin female connector in the rear of the wheel arch.
-
Use a tie strap from the kit. Clamp the remaining white (W) two pin female connector to the adapter wiring (3) at the existing cable harness.
-
Plug the green (GN) five pin male connector (4) into the routed green (GN) five pin female connector, which is clamped in the front edge of the
large hole in the side of the body.
-
Use a tie strap from the kit. Clamp the remaining green (GN) five pin female connector to the adapter wiring (5) at the existing cable harness.
Applies to cars with a 12V socket
-
Connect the white (W) two pin male connector on the adapter cable (2) to the white (W) two pin female connector that was disconnected from the
12V socket.
-
Connect the remaining white (W) two pin female connector on the adapter wiring (3) to the 12V socket.
Illustration B
Applies to cars with a tow hitch
-
Detach the green (GN) five pin female connector (6) from the Trailer Module (TRM). Plug it into the green (GN) five pin male connector (4,
illustration A) on the adapter cable.
-
Plug the adapter cable's green (GN) five pin female connector (5, illustration A) to the Trailer Module (TRM).
Illustration C
