V50 L5-2.4L VIN 39 B5244S7 (2005)
NOTE: Do not apply rust solvent spray or grease to the Heated Oxygen Sensor (HO2S) or combined instrument panel connectors.
-
Ignition off
-
Disconnect the battery negative terminal
-
Use compressed air to clean the disconnected connector
-
Apply rust solvent spray 1161422 to the disconnected connectors
-
Blow clean using compressed air.
NOTE: Do not fill the protective cover with grease.
-
Press grease, P/N 1161417-9, into the terminals directly from the tube
-
Check that all the cavities in the connectors are filled
-
Use a loose male pin to ensure that contact in sockets is good. The pin should remain in position when pulled gently.
Wiring Harness Supplemental Restraint System (SRS)
Wiring harness supplemental restraint system (SRS)
Special tools:
951 2620 Stripping tool See: Tools and Equipment/951 2620 Stripping tool
951 2777 Hot-air gun See: Tools and Equipment/951 2777 Hot-Air Gun
