V50 L5-2.4L VIN 39 B5244S7 (2005)
Note! The illustration shows a left-hand drive car. On right-hand drive cars the cable must be pulled out to the left.
-
Connect the sensors to the cable harness connectors.
Note! A click should be heard when connecting. The noise confirms that the catch has locked.
-
Secure the cable by applying activator (P/N 8037076) where the cable is to be positioned.
-
Secure the cable by the bumper cover. Use butyl tape.
Installing the cable harness from the bumper
Note! Illustrations 29 - 38 show a left-hand drive car. Carry out the procedure on the left-hand side of the car on right-hand drive vehicles.
-
Take the short cable from the kit
-
Pull the end with the loose terminal pins in under the headlamp
-
Continue to pull the (1) cable along the right-hand side of the car, under the expansion tank down to the cowl panel
-
Route the cable so that it is concealed and cannot be damaged or worn. Secure the cable so that it does not move.
Note! Ensure that the cable does not lie against any moving components or too close to heat sources.
Note! Illustrations 31 - 34 display making holes from inside the passenger compartment on the right-hand cowl panel.
