V50 L5-2.4L VIN 39 B5244S7 (2005)
-
Fit the sensor holders in the filed out recesses on the outside of the bumper cover. Press them in so that the holders' hooks engage in the bumper
cover.
Note! All the holders are unique in terms of their shape and only fit in one of the holes. Check that the hole is correct before fitting the
holder and pressing it in.
-
Fit the sensor cable in the clip brackets.
-
Fit the sensors in the sensor holders so that they fasten securely.
-
Adjust the sensor holders precisely so that the connectors are horizontal.
-
Connect the sensor cable connectors to the sensors. The sensor cable's loose connector must now come out from the right-hand side of the bumper
cover.
-
Lift up the bumper cover into position. Plug the sensors' connector into the connector secured below the right-hand rear lamp.
-
Refit the bumper cover by following the instructions for removal in steps 12-14 in reverse order.
Installation of the Parking Assistance Module (PAM)
