V50 L5-2.4L VIN 39 B5244S7 (2005)
Keyless Starting System: Testing and Inspection
Information and verification, locking/unlocking keyless lock and starting system
Symptom and function description
For locking and unlocking to be permitted by the keyless system, the following conditions must be met:
-
The remote key must be on the same side of the vehicle as the door to be unlocked.
-
The remote key must be within a radius of 1.5 meters from the vehicle's door handle as the antenna is located in the door handle.
-
The battery in the remote key must have sufficient voltage. If the battery starts to deteriorate, the transmission strength is reduced.
-
All doors should be shut and the car should be locked.
Note! How many doors and hoods are to be locked and unlocked, when using the remote key/PCC (Personal Car Communicator) and the
exterior flashing indication, can be programmed on the Infotainment control module (ICM).
Note! It has become apparent that in some cases function failure occurs in the system when communications between the Remote Keyless Entry
(RKE) and the remote key/PCC (Personal Car Communicator) are affected by interference. On account of increased radiation in the
surroundings, e.g. from TVs and radio transmitters, mobile phones, electric meters that are readable remotely, etcetera, on rare occasions
interference may affect the signal from the remote key/PCC (Personal Car Communicator).
Hint: For more information, see Design and Function.
Verification
Check the keyless system and the central locking system by standing outside the car and trying to lock and unlock the doors.
Check that the LED on the inside of the each door is lit for about five minutes after the vehicle is locked using the remote receiver or with the "Keyless
drive-system".
Also check that the boot lid locks and unlocks.
Check using all the vehicle's remote keys.
Pre-check:
-
That the text REMOTE CONTROL REPLACE BATTERY was not visible on the Driver information module (DIM) display.
-
Configuration for locking in Infotainment Control Module (ICM).
Hold a remote key in your hand. Press the lock button on the outside of the door handle and check that the vehicle is locked.
Wait 1 minute after locking, then pull out the door handle and check that the vehicle unlocks.
If the function fails, when one of the remote keys is used, the fault probably lies with the individual remote key.
-------------------------------------------------
