V50 L5-2.4L VIN 39 B5244S7 (2005)
^
lastly tighten the three EHPAS pump fastening screws (B).
5d.
Reinstall front bumper
Reinstall front bumper and protecting casing according to VIDA.
6.
If the noise is still present:
^
Flush the entire power steering system with new fresh oil (flushing instructions below).
^
Once the system has been flushed, fill up with new power steering oil.
^
Test drive the car to determine if the noise is still present.
7.
If the noise is still present after flushing the power steering with new oil, replace the EHPAS pump according to VIDA.
Flushing instructions:
^
Park the car for a while before the procedure to reduce the oil temperature in the system.
^
Disconnect the return hose from the EHPAS pump, and put a clean empty container of at least 2 quarts capacity (2 liters) under the return hose.
^
Start the engine and begin to collect the oil in the container. Add new power steering oil to the EHPAS pump at the same time old oil is
drained from the return hose.
Caution!
Power steering oil may be hot.
^
When a total amount of approximately 2 quarts (2 liters) of power steering oil has been collected in the container, turn off the engine and
reinstall the return hose.
Note!
Used power steering oil should be disposed of in an environmentally safe manner.
WARRANTY CLAIM INFORMATION
