V50 AWD L5-2.5L Turbo VIN 68 B5254T3 (2005)
-
Clean the roof around the existing antenna dummy, above the rear windscreen
-
Apply tape around the antenna dummy to prevent paintwork damage when the antenna dummy is cut off.
-
Remove the antenna dummy. Cut around the antenna dummy. Use handles P/N 9512333 with a thin piano wire.
NOTE: There are three locating pins in the antenna dummy so pull the wire from both ends. Pull evenly to prevent paintwork damage.
-
Remove the tape.
NOTE: To ensure the best results, it is recommended that two people press the new antenna onto the roof. One person should push against the
inside of the roof to prevent buckling when the antenna is pressed down.
-
Clean the area on the roof where the new antenna is to be positioned. Use a mixture of 30% isopropanol and 70% water. Wipe dry
-
Remove the protective film from the tape on the antenna
-
Align the locating pins for the antenna in the corresponding holes in the roof. Press the antenna securely into place.
NOTE: Apply pressure to the antenna for at least 30 seconds so that the tape secures properly.
-
Turn the clip 90 degree . Remove the clip from the headlining
-
Carefully fold down the centre section of the rear end of the headlining. Find the pre-routed cable for the antenna behind the hole for the interior
lighting.
