V50 AWD L5-2.5L Turbo VIN 68 B5254T3 (2005)
-
Remove the cover for the washer nozzle.
Hint: Carefully grip the cover. Pull the cover out until the catch becomes accessible from the underneath.
-
Press the catch up. Remove the cover. Do not damage the painted surfaces and washer nozzles.
-
Detach the ends of the bumper cover on the left and right-hand sides. Grasp the end of the bumper cover inside the wing liner. Carefully pull the
end of the bumper cover so that the two catches under the lamps release. Lift off the bumper cover
-
Disconnect the connectors for the fog lamps, if installed.
-
Carefully place the bumper on a flat surface.
Note! Do not damage the painted surfaces.
-
Pre-drill holes in the centre of the drill markings on the inside of the bumper cover. Pre-drill using a -3 mm (1/8") diameter drill bit.
-
Drill out the holes from the inside. Use a -8 mm (5/16") diameter drill bit.
