V50 AWD L5-2.5L Turbo VIN 68 B5254T3 (2005)
-
Dry the area completely with compressed air
-
Seal the marked area with sealing compound (PN 1161767); make sure the area is completely sealed
-
After the sealant has hardened (approx 6 hrs), check the water tightness of the area again.
-
If the area is now sealed, touch up the area with the appropriate touch-up paint.
3.
Remove any water from the A pillar
Remove the affected side front door.
-
Lower the window 12 inches (30 cm).
-
Ignition off.
-
Disconnect the door assembly harness.
-
Remove the door from the vehicle as shown.
With the door removed, you will have access to inspect the inside of the A pillar area.
TIP:
Use a light to inspect this area.
