V50 AWD L5-2.5L Turbo VIN 68 B5254T3 (2005)
-
Install the front engine block heater socket connector in the hole underneath. Centre it in the middle of the hole. Tighten the connector using the
screw and the mounting plate from the kit.
Cable routing
-
Install three clips from the kit on the panel edge on the underside of the left front member.
Illustration A
-
Reinstall the bumper cover. Use the five clips and the two screws at the top. Remove the air baffle from the lower section of the bumper cover.
This makes it possible to route the cable between the left-hand end of the front grille and the seal in front of the radiator
-
Route the cable for the front engine block heater socket through at the seal by the left-hand end of the lower front grille. Route the cable over the
left-hand bracket (1) for the radiator and up to the underneath of the side member. Clamp the cable at the bracket (1). Use a tie strap from the kit.
Route the cable along the underneath of the front member and over the drive shaft. Raise the cable a little in the engine compartment.
Illustration B
