V50 AWD L5-2.5L Turbo VIN 68 B5254T3 (2005)
-
Install the front engine block heater socket in the hole below, centre it in the hole. Tighten in the connector using a Torx screw (L=40 mm) and the
mounting plate from the kit.
Applies to the S40 and V50, MY 07-
-
Remove the seven screws from the engine splash guard.
-
Remove the four screws.
-
Angle out the lower part of the bumper (1).
-
Pull out the air baffle from the guides on the bumper and pull downwards slightly (2).
