V50 AWD L5-2.5L Turbo VIN 68 B5254T3 (2005)
-
the ignition coils according to the marking made during dismantling
-
earth points, 2
-
cable conduit at the rear edge of the cylinder head.
Connect the connectors to:
-
the variable valve timing (VVT) solenoid
-
the camshaft position sensor
Installing parts
Install:
-
the upper belt protection cover and tighten the screws
-
the front/upper belt protection cover by pushing it into position on the upper one.
Fit the front engine bracket
Install:
-
the engine bracket
-
the screws (2) to the engine bracket on the cylinder head
-
movement limiter
-
the screws (1) to the movement limiter for the engine bracket on the right-hand frame side member. Tighten according to: Tightening torque.
Remove the lifting brace 999 7103
Push on the expansion vessel and secure the hoses.
Fitting the upper intake manifold
Caution: Ensure that the guides for the lower section are in the correct position.
