V50 AWD L5-2.5L Turbo VIN 68 B5254T3 (2005)
Lift the coolant hose out of the holder/bracket.
Remove:
-
the nuts for the coolant hose bracket. Bend the bracket to one side to access the screws for the starter motor
-
the flat pin contact and the positive cable from the starter motor
-
the screws holding the starter motor against the transmission. Lift out the starter motor.
Installing the crankshaft adjustment tool
Caution! Ensure that the tool bottoms out against the cylinder block.
Remove the blind cover plug from the hole for the adjustment tool. Turn the crankshaft clockwise slightly. Use: 999 5451 ADJUSTMENT TOOL See:
Tools and Equipment/999 5451 Adjustment Tool.
Aligning the crankshaft
Turn the crankshaft counter-clockwise until it stops against the adjustment tool.
Check that the marking on the crankshaft timing gear pulley corresponds to the marking on the oil pump.
Installing the variable valve timing (VVT) unit on the camshaft
