V50 AWD L5-2.5L Turbo VIN 68 B5254T3 (2005)
-
Connect by pressing in the connector catch.
Applies to 4-pin towbar wiring
-
Refit the ends of the cables in the connector in as follows:
-
Connect by pressing in the connector catch.
Installing the sensors
Note! Take care that the activator has dried (at least 10 minutes) before painting
-
Position the sensors so that you can paint the sensor surface without them overturning. Spray the sensors with the same colour as the car. Use paint
recommended by Volvo. Apply a maximum of two layers of paint.
Caution! Too many layers of paint may result in partial or complete malfunction.