volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Campaign - A-Pillar Harness Connector Corrosion|Page 15786 > < Campaign - A-Pillar Harness Connector Corrosion|Page 15784
Page 5
background image

Installing front door
Carefully lift the door into place.
Caution! Get help from a co-worker
during this step.
Install the screws to the hinges. Tighten to
24 Nm

Continue to step 19.

If corrosion is found in the connector, follow the instructions below.

9.
Replacing connector in a-pillar
If there is corrosive damage on the
connector, it must be replaced with two
moisture-proof connectors.
Cut off the leads as close as possible to the

Campaign - A-Pillar Harness Connector Corrosion|Page 15786 > < Campaign - A-Pillar Harness Connector Corrosion|Page 15784