V50 AWD L5-2.5L Turbo VIN 68 B5254T3 (2005)
Remove the cover.
Use gasket wedge 999 5477 JOINT WEDGE See: Tools and Equipment/999 5477 Joint Wedge. Tap the wedge carefully into the joint between the
cover and the transmission to ensure that the cover sealing flange is not distorted.
Checking and cleaning
Clean the gasket residue from the cover and the transmission.
Note! Make sure that no debris enters the transmission. Wash the cover thoroughly.
Check that the mating surface for the cover is level.
Installation
Applying liquid seal
Wipe the cleaned mating surfaces on the cover and transmission. Use isopropyl alcohol.
Apply an approximately 3 mm thick bead of liquid sealant (P/N 116 1409-6) to the cover. Also apply sealant around the screw holes.
Installing the control system cover
