V50 AWD L5-2.5L Turbo VIN 68 B5254T3 (2005)
Note! Make sure that no damage is caused when removing the throttle valve. The valve cannot be replaced separately. The throttle valve is
removed in order to be installed in the differential electronic module (DEM). This is done to minimize the risk of damage occurring to the
contacts when installing.
Installation
Note! For tightening torques, see Specifications. See: Automatic Transmission/Transaxle/Specifications/Mechanical Specifications/Tightening
Torque
Installing components
Install:
-
control module
-
the sealing plate
-
washer
-
the throttle valve with O-rings
-
the temperature/pressure sensor with O-ring
-
the O-ring for the throttle valve seat
-
the screws.
Positioning the sealing plate in the control module
Press the throttle valve and temperature/pressure sensor into place on the control module contacts.
Place the cupped washer with the convex side against the temperature/pressure sensor.
Lubricate the sealing rings on the valves with oil, P/N 116 1641-4 (0.3 liters).
Installing the O-ring
