V50 AWD L5-2.5L Turbo VIN 68 B5254T3 (2005)
Use a large pair of pliers for removal. Grip the end of the throttle valve. Hold the pliers stable and pull the valve straight out.
Note: Make sure that no damage is caused when removing the throttle valve. The valve cannot be replaced separately. The throttle valve is removed
in order to be installed in the differential electronic module (DEM). This is done to minimize the risk of damage occurring to the contacts when
installing.
Remove:
-
the temperature/pressure sensor as above
-
the O-ring from the throttle valve seat in the coupling housing.
Installation
Note: For tightening torques, See: Specifications.
Installing components
Install:
-
the control module
-
the sealing plate
-
washer thin throttle valve With O-rings
-
the throttle valve with O-rings
-
the temperature/pressure sensor with O-ring
-
the O-ring for the throttle valve seat
-
the screws.
Components that are included in the kit and must be replaced
-
the temperature/pressure sensor with O-ring
-
washer
-
the O-ring for the throttle valve seat.
Position the sealing plate in the control module Press the throttle valve and temperature/pressure sensor into place on the control module contacts.
Place the cupped washer with the convex side against the temperature/pressure sensor. Lubricate the sealing rings on the valves with oil, P/N 116
1641-4 (0.3 liters).
