V50 AWD L5-2.5L Turbo VIN 68 B5254T3 (2005)
From inside the vehicle, be sure no water is entering the area. If so, locate the exact spot (pictures 1 & 2 might give you a hint of a possible location)
NOTE:
Prior to reinstalling the A pillar cover, see SERVICE for additional possible source of water intrusion.
If no leak is detected, install a new retaining clip (PN 30781445) on both A pillars, install the cover panels and proceed to the next possible cause. See
SERVICE
If a leak has been detected, do not remove the windscreen, perform the following:
-
Dry the area completely with compressed air
-
Apply sealing compound (PN 1161767) by use of a generic sealant gun. (insert a small spacer between the headliner and flange in the top corner for
better access)
-
Ensure the application of sufficient amount of sealant, remove excess sealant with a 'wet' finger or spatula
-
After the sealant has hardened (approx 6 hrs), check the water tightness of the area again.
NOTE:
Prior to reinstalling the A pillar cover, see SERVICE for additional possible source of water intrusion.
-
Install a new retaining clip (PN 30673305) to both A pillars
