V50 T5 L5-2.5L Turbo VIN 68 B5254T3 (2006)
Steps 48-49 apply to EU cars with RTI and CH 78749-
-
Disconnect the fibre optic cable (1) from the underside of the amplifier.
-
Take the T-fibre optic cable (B in the kit illustration) from the kit. Connect the long end (1) to the subwoofer.
-
Connect the female connector of the adapter fibre optic cable to the connector on the fibre optic cable that was disconnected from the amplifier.
-
Connect the male connector (3) of the adapter fibre optic cable to the amplifier.
-
Secure the cable splice terminals to the fibre optic cables using the clip (2) for the panel edge.
Note! Do not bend the fibre optic cable too tightly.
-
Check the bend radius of the fibre optic cables. If the bend radius is less than 25 mm (1"), remove the tape from the thick cable harness and
increase the radius.
Connecting the power supply cable
Illustration A
