V50 T5 AWD L5-2.5L Turbo VIN 67 B5254T7 (2008)
-
Route the cable inside the floor carpets and the lower B post panel on towards the rear edge of the right-hand rear wheel arch. Route the cables
along the existing cables harnesses in the cargo compartment.
Caution! Ensure that the cable is positioned so that there is no risk of it catching or rubbing.
-
Connect the pre-routed cable to the middle connection on the Parking assistance module (PAM). It is on the right-hand side in the cargo
compartment behind the wheel housing.
Note! Make sure that the connector clicks into place and is properly secured.
-
Hold the bumper up against the car and connect the connector for the sensor cable to the connector secured in the car.
-
Secure the assembled connector on the member (1). Use a tie strap on each side of the connector
-
Guide the bumper cover into the guides
-
Slide the bumper cover into the correct position
-
Reinstall the bumper cover by repeating points 18 - 21 in reverse order.
Finishing work
