V50 T5 AWD L5-2.5L Turbo VIN 67 B5254T7 (2008)
-
Wash out the bumper cover. Use a mild soap solution.
-
Clean around the holes and markings using isopropanol and allow to dry.
-
Apply a thin and even coat of activator to the cleaned surfaces. Allow to dry for approximately 10 minutes.
-
Check which holders are to be placed where before installing. Each holder is marked and has its own specific place. The holders must be
positioned as illustrated.
1. 1 Right outer
2. 2 Right inner
3. 3 Left inner
4. 4 Left outer
-
Install the sensors in their holders.