V50 T5 AWD L5-2.5L Turbo VIN 67 B5254T7 (2008)
-
Install the sensor holders (1) horizontal with the bumper cover as illustrated and secure them.
-
Connect the cable harness connectors to the sensors. A click should be heard on connection. The noise confirms that the catch has engaged. Take
care when installing so that the holder does not come loose from the tape.
Note! The large gray connector must protrude from the right-hand side of the bumper cover.
-
Secure the cable harness with butyl tape as illustrated.
Steps 44-57 apply to both the S40 and V50
-
Remove the rubber grommet from the hole in the car, it shall not be re-used.
