V50 T5 AWD L5-2.5L Turbo VIN 67 B5254T7 (2008)
-
Disconnect the rear connector (1) on the amplifier.
-
Remove cable harness (C) from the kit.
-
Connect the cable harness to the amplifier as follows: Connector (1) which is disconnected from the amplifier is connected to the female connector
(2) on the cable harness. Connector (3) on the cable harness is connected to the amplifier.
-
Tape one section of the cut piece of foam tape around connectors (1) and (2).
-
Secure the excess cable using one of the cut up parts of foam tape and two short tie straps, on the existing cable harness of the vehicle
Applies to the V50
-
Reinstall the insulation panel on the left-hand side.
Applies to the S40 and V50
-
Take the relay and 2 thick pieces of foam tape from the kit.
-
Connect the connector from cable harness C and the routed cable harness connector to the relay.
-
Fit 2 pieces of tape around the relay.
