V50 T5 AWD L5-2.5L Turbo VIN 67 B5254T7 (2008)
Installing the amplifier:
-
Remove the three nuts holding the amplifier to the body
-
Pull the amplifier out slightly. Disconnect the three connectors on the underside. Put the amplifier to one side. It will not be used again
-
Take the new amplifier from the kit. Connect the connectors on the underside
-
Install the amplifier on the studs
-
Install and tighten the three nuts. Tighten to 10 Nm (7.5 lbf. ft.).
Applies to cars with RTI (road traffic information)
Installing the amplifier Illustration A
-
Remove the three nuts holding the amplifier to the body
-
Pull out the amplifier. Place the amplifier on the cargo compartment floor with the reverse upwards.
Illustration B
-
Remove the screw that holds the bracket with the GPS antenna in the amplifier
-
Unhook the bracket from the amplifier
-
Remove the three connectors from the bottom of the amplifier. Place the amplifier to one side. It will not be used again