V50 T5 AWD L5-2.5L Turbo VIN 67 B5254T7 (2008)
INTRODUCTION
-
NOTE! Read through the whole installation instruction before starting the work.
-
The front page gives the date of this edition and the edition it replaces
-
The second page shows the tools needed for the installation and the contents of the installation kit
-
The illustrations display the procedure in order of operation. The order of operation is repeated in the text section
-
Cut out the text page in order to follow the illustrations and text at the same time.
Parking assistance, Rear
Note! During installation, the car and components must maintain a temperature of at least +20° C (68° F).
-
Steps 3-25 only apply to the V50
-
Steps 26-43 only apply to the S40
Preparations
Illustrations A and B
-
Take 4 sensors and holders from the kit.
-
Clean the surfaces of the sensors and holders using isopropanol as illustrated.
-
Allow to dry.
-
Apply a thin and even coat of activator on the cleaned surfaces and allow to dry for a minimum of 10 minutes and a maximum of 30 minutes