volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Towbar, Wiring, 4-pin|Page 17369 > < Towbar, Wiring, 4-pin|Page 17367
Page 13
background image

-

Press the connected connector into the trailer module (TRM).

-

Connect the ground lead from the routed cable harness to the ground terminal under the tail lamp and tighten the screw properly.

Applies to the V50

-

Reinstall the AM/FM tuner module (AFM) / traffic message channel module (TMC).

-

Reinstall the insulation panel.

Applies to the S40 (04-)/V50

-

Reinstall the Parking Assistance Module (PAM), if the car is equipped with one. Reinstall other detached cables.

-

Reinstall the side panel. If the car has a 12V socket, connect the connector to this.

Applies to the V50

-

Tighten the screws for the load securing eyelets. Tighten to 24 Nm (18 lbf.ft.).

-

Reinstall the panel at the front/top of the side panel. Press downwards so that the catches engage. Tighten using the screw.

-

Reinstall the C-post panel.

-

Reinstall the rubber strip at the rear edge of the opening for the rear door.

-

Reinstall the side bolster.

Applies to the S40 (04-)/V50

-

Reinstall the rubber strip in the tailgate opening.

-

Reinstall the sill trim panel in the tailgate opening.

Applies to S40 (04-)

-

Reinstall the upper floor support if applicable.

Applies to the S40 (04-)/V50

-

Reinstall the cargo compartment carpet.

Applies to the V50

-

Fold the backrest and seat back into place.

Applies to the S40 (04-)/V50

-

Reinstall the bumper cover.

Towbar, Wiring, 4-pin|Page 17369 > < Towbar, Wiring, 4-pin|Page 17367