V50 T5 AWD L5-2.5L Turbo VIN 67 B5254T7 (2008)
Carry out on both the left and right-hand sides:
-
Detach the end of the bumper cover. Grasp the bumper cover inside the wing liner and pull carefully until the six catches at the top edge release
(illustration A)
-
Remove the bumper cover by pulling it straight backwards (illustration B).
-
Clean any underseal and dirt from the collision member where the L-profile for the tow hitch is to be located
-
Take the L-profile, four M10x30 flanged screws and four flange nuts from the kit. Install the L-profile on the collision member as illustrated. Do
not fully tighten yet.
Securing the tow hitch wiring connector to the bracket:
-
Take the assembled connector from the kit for the four-pin wiring
-
Take the bracket from the tow hitch kit
-
Secure the connector on the bracket using the two screws and nuts.