V50 T5 AWD L5-2.5L Turbo VIN 67 B5254T7 (2008)
-
Press the cut sections of the roof trim into the clips in the roof joint. Check that the marking on the long roof trim (1) is opposite the marking on
the roof (2). Also check that the front and rear angled ends of the roof trim align in the rounded section of the roof.
Installing the rails
-
Check that the rubber spacing is correctly positioned under the feet of the rails
-
Carefully position the rails over the holes in the roof join
-
Install the screws from the kit
-
Tighten the screws alternately at the front and rear edges to prevent deformation. Tighten the screws. Tighten to 10 Nm (7.7 lbf.ft).
-
Install the cover on the front mounting for the rail
-
Insert the two locating pins for the cover in the rail, as illustrated
-
Fold the cover down towards the front mounting. Press it into place
-
Repeat the operation for the rear mounting cover
-
Remove the tape on the roof and the roof trim
-
Repeat on the other side.
