V50 T5 AWD L5-2.5L Turbo VIN 67 B5254T7 (2008)
-
NOTE! Read through the whole installation instruction before starting the work.
-
The front page gives the date of this edition and the edition it replaces
-
The second page shows the tools needed for the installation and the contents of the installation kit
-
The illustrations display the procedure in order of operation. The order of operation is repeated in the text section
-
Cut out the text page in order to follow the illustrations and text at the same time.
Roof spoiler
Applies to the V50 with mini-spoilers on the rear window
-
Remove the spoilers from the rear window using a weatherstrip tool, they are secured with double-sided adhesive tape.
Take care not to scratch the window.
-
Clean the rear window of tape residue.
Applies to all models
-
Clean the mating surfaces of the spoiler against the tailgate. Use a mixture of 30% windscreen washer fluid and 70% water. Wipe dry.
-
Take the tape from the kit. Remove the thin backing tape. Press the tape firmly into place on the mating surfaces. Allow the thicker backing tape to
remain in place.
-
Take the tape washers from the kit. Remove the thin backing tape. Allow the thicker backing tape to remain in place.
-
Press the tape properly into place on the projections on the spoiler where the studs are attached.
Spray paint according to the "Touch up spraying" service instructions.
Note! The tape must cure for 24 hours at a minimum of 20°C before painting.
