V50 T5 AWD L5-2.5L Turbo VIN 67 B5254T7 (2008)
-
Each person should hold one end of the roof spoiler. Carefully insert the studs (1) in the underside of the roof spoiler in the front drilled holes.
Ensure that the tape is not sticking to the tailgate yet.
-
Open the tailgate. Screw in the two screws with washers (2) from the kit into the tailgate spoiler a few turns.
-
Press the roof spoiler against the tailgate so that the tape is properly secured (otherwise there is a risk of the tape coming loose when installing the
screws and nuts). Tighten the two nuts and washers (3) from the kit. Tighten the screws. Tighten the nuts and screws. Tighten to 5 Nm (3.7 lbf. ft)
-
Post-tighten the screws and nuts after 5 minutes.
-
Reinstall the panels and the handle on the inside of the tailgate.
-
Install the two cover plugs from the kit over the large drilled holes on the inside of the tailgate.
Note! After installing the roof spoiler, leave the car indoors for 2 hours before driving.
Note! Do not wash the car for at least 48 hours after installing the roof spoiler.
Spoiler Rear
Spoiler rear
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Information
Important information
Note! This method only applies to the S40 Sport and V50 Sport.
Removal
Removing the rear spoiler
Remove:
-
the 2 x screws (1).