V50 T5 AWD L5-2.5L Turbo VIN 67 B5254T7 (2008)
Install:
-
the battery box (2)
-
the 3 M6 screws (1)
-
the battery as shown: Battery See: Starting and Charging/Battery/Service and Repair/Removal and Replacement.
Ordering software
Note! When replacing the hydraulic modulator, new software must be programmed into the brake control module (BCM).
Order software. See: See: Testing and Inspection/Programming and Relearning/Software Downloading
Calibrating the control module
Note! Only applies to control modules with DSTC function.
Use VIDA vehicle communication to calibrate the control module
Finishing
Final check
Ignition on.
Wait five seconds and until the symbol for the brakes on the dashboard has gone out.
In the event of a fault (the symbol is lit).
Check that the connector is connected.
Read off any diagnostic trouble codes (DTCs) stored in the control module.
Erase. Interrupt the diagnostic function by turning off the ignition.
Test drive the car, see: Test Drive Form (ABS), description See: Antilock Brakes / Traction Control Systems/Testing and Inspection/Initial Inspection
and Diagnostic Overview/Test Drive Form (ABS).
