V50 T5 AWD L5-2.5L Turbo VIN 67 B5254T7 (2008)
Illustration B
-
Take the heater, the rubber-covered clamp, the bracket, and the self tapping screw from the kit. Assemble as illustrated. The short pipes (1) for the
heater must be at right-angles to the long side of the bracket (see illustration B). Ensure that the short pipes for the heater are centered in relation to
the cut-outs (2) in the bracket where the heater will be screwed into place
-
Do not fully tighten the rubber clamp yet.
-
Take two heater hoses and four hose clamps from the kit
-
Install the two hoses on the heater with the shortest hose at the top
-
Tighten the hoses to the heater in the positions illustrated. Use the hose clamps.