V50 T5 AWD L5-2.5L Turbo VIN 67 B5254T7 (2008)
Intake Manifold: Service and Repair
Intake Manifold/Gasket, Replacing
Intake Manifold/Gasket, Replacing
NOTE: The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the essential
information in the illustrations is always correct.
Preparatory work
Removing components
Drain the fuel system.
Remove the air cleaner (ACL) module.
Remove:
-
the hose clamp for the rubber hose on the throttle body (TB). Move the hose to one side. Disconnect the throttle body (TB) connector
-
the brake vacuum hose on the intake manifold.
Removal
Removing upper intake manifold
Remove the 6 screws for the upper section of the intake manifold. Disconnect the vacuum hoses from the intake manifold. Put the pipe to one side.
Removing the fuel rail
CAUTION: Clean up any spilled fuel using paper.
Disconnect the connectors for the fuel pressure sensor and the connector for the injectors. Remove the 2 fuel rail mounting screws. Spray universal oil or
similar around the injector nozzle at the terminal on the intake manifold. Gently work the fuel rail and injector nozzles loose. Disconnect the fuel line to
the fuel rail. Press in the two blue clips on the fuel rail. Pull the fuel line out of the fuel rail. Place the fuel rail to one side.
Removing components
Remove:
