volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 211 > < Initial Inspection and Diagnostic Overview|Page 209
Page 3
background image

The Integrated Audio Module (IAM) has a ground input. The ground input from the control module is connected via a ground cable to the ground
terminal in the body. For further information on ground terminals, see the relevant wiring diagram.

-

Ground input 1 (#A8) is power ground and connected to the ground connection in the body.

Checking the ground terminal

Check the ground cable between Integrated Audio Module (IAM) terminal (#A8) and the ground terminal. Check for an open-circuit. Check for loose
connections. Check for contact resistance and oxidation. With the ignition on, the drop in voltage between the ground connection for the Integrated
Audio Module (IAM) and the ground terminal must not be greater than 0.5 V.
Remedy as necessary.

Other information

-

Signal specification See: Pinout Values and Diagnostic Parameters/Signal Description, Integrated Audio Module (IAM) 

-

See the relevant wiring diagram for information about circuits and ground terminals in the bodywork.

-

Checking wiring and terminals See: Testing and Inspection/Component Tests and General Diagnostics/Checking Wiring and Terminals 

Continue - DONE

-------------------------------------------------

Checking The Supply Voltage/Ground Terminal, Multimedia Module (MMM).

Checking the voltage / ground terminal

Power supply multimedia module (MMM)

Multimedia module (MMM) is supplied with voltage via a voltage input on the control module.
When the ignition is on, the power input is powered and the multimedia module (MMM) is in active mode.

-

Voltage input 1 (#21 (#A1)) is supplied with voltage via a relay connected on the Central electronic module (CEM). The relay is powered via a
fuse from the battery. The relay coil can be diagnosed by the central electronic module (CEM). The multimedia module (MMM) will not be
activated if there is an open-circuit.

Checking the power supply

Check the power supply cable from the battery to the relay on the Central electronic module (CEM) and from the relay to the Multimedia module

Initial Inspection and Diagnostic Overview|Page 211 > < Initial Inspection and Diagnostic Overview|Page 209