V50 T5 AWD L5-2.5L Turbo VIN 67 B5254T7 (2008)
-
Clean the inside of the bumper cover using a mild soap solution.
-
Clean an area around the holes that is slightly larger than the sensor holder. Use isopropanol.
-
Allow to dry.
-
Apply a thin and even coat of activator to the cleaned surfaces and allow to dry for approximately 10 minutes.
-
Locate the two marks on the plastic member (the energy absorbent). Saw out following the two markings using a compass saw, only through the
outer section.
Note! On certain cars a foam member is available instead of the plastic member.
-
Remove the foam member from the collision member.
-
Make cut-outs for the inner sensors by sawing out according to the two markings through the entire thickness of the foam member.
-
Reinstall the foam member.
-
Cut out for the cable harness in the foam member by the two cut-outs. The cut-outs must be 25 mm (1") wide and 15 mm (9/16") deep.
