V50 T5 AWD L5-2.5L Turbo VIN 67 B5254T7 (2008)
-
Install the sensors in their holders.
-
Clean the surfaces of the holders using isopropanol as illustrated.
-
Allow to dry.
-
Apply a thin and even coat of activator to the cleaned surfaces and allow to dry for at least 10 minutes.
-
Remove the protective backing film from one side of the tape.
-
Apply the tape (1) on the sensor holder.
-
Remove the protective film from the pieces of tape on the sensor holder.
-
Carry out the procedure above for the three remaining sensor holders.
Note! The tape adheres immediately.