V50 T5 AWD L5-2.5L Turbo VIN 67 B5254T7 (2008)
-
Apply a thin and even layer of adhesive (1) to the holders. Use glue gun part no. 9512950. The adhesive must be slightly above the level of the
tape.
Note! The adhesive must not come into contact with the tape. The task of the tape is to secure the holders to the bumper cover until the
adhesive has cured after approximately 24 hours.
-
Install the sensor holders horizontal with the bumper cover as illustrated and secure them.
Caution! Incorrect positioning of the sensors may result in partial or complete malfunction.
-
Connect the cable harness connectors to the sensors. A click should be heard on connection. The noise confirms that the catch has engaged. Take
care when installing so that the holder does not come loose from the tape.
Note! The large gray connector must protrude from the right-hand side of the bumper cover.
